Veritas Flex Appliance Getting Started and Administration Guide

To configure Flex Appliance

1. Review the initial configuration guidelines and checklist to make sure that you have all of the necessary information to complete this procedure.

   See Initial configuration guidelines and checklist.

2. Use the following steps to access the Flex Appliance Shell from the Veritas Remote Management Interface:

   • Open a supported web browser on a system that has a network connection to the appliance. Flex Appliance supports the following browsers:

     • Google Chrome version 94 or later recommended (minimum version 80 or later)

     • Mozilla Firefox version 93 or later recommended (minimum version 80 or later)

   • Enter the IP address that is assigned to the remote management (IPMI) port of the appliance node. If you have a multi-node appliance, select one of the nodes to use to begin the initial configuration.

   • Log in to the Veritas Remote Management Interface with the following default credentials:

     • Username: sysadmin

     • Password: P@ssw0rd

   • Change the sysadmin password from the known default password as follows:

     • Navigate to Configuration > Users and select the sysadmin user.

     • Click Modify User.

     • Select the Change Password check box and enter a new password.

   • Do one of the following to launch the Flex Appliance Shell:

     • Navigate to Remote Control > Console Redirection and click Launch Console.

     • If available, navigate to Remote Control > iKVM over HTML5 and click Launch Console over HTML5.

     Note:

     Availability of the HTML5 option depends on the appliance firmware version. You can check the version from the System > System Information page. The BIOS ID must show version 00.01.0016 or later.

3. Log in to the Flex Appliance Shell with the following default credentials:

   • Username: hostadmin

   • Password: P@ssw0rd

   See Accessing and using the Flex Appliance Shell.

4. Enter the following command to change the password for the hostadmin user:

   set user password

5. Enter the following command to configure the host network:

   setup configure-network

   Follow the prompts to enter the host network information. You can enter multiple DNS server IP addresses or search domains using a comma-separated list.

   Note:

   The Flex Appliance Shell does not support changing host network settings other than the DNS and Hosts file settings after initial configuration has been completed. If you need to change any of the other host network settings, you must perform a factory reset and then restart the initial configuration process.

6. If you did not fill in the optional DNS parameters or want to bypass DNS for specific hosts, you must add the hostname resolution information to the appliance Hosts file. Use the following steps:

   • Enter the following command:

     system add-host

   • One at a time, enter the required hostname information for the following:

     • The node

     • The Flex Appliance Console if the setup configure-network prompts asked for it

     You can also add the information for the other node if you have a multi-node appliance, as well as any instances you plan to create, or you can add that information later.

7. Enter the following command to configure the Flex Appliance Console:

   setup configure-console

   Follow the prompts as applicable to your appliance to enter the console network information.

   Note:

   Depending on the number of storage shelves you have in the appliance, this step may take up to 15 minutes to complete. When it is complete, the shell refreshes with new command options.

8. (Optional) Use the set date commands to set the date and time for the appliance. See Setting the date and time for appliance nodes.
9. If you have a single-node appliance, the initial configuration process is now complete. Proceed to the next steps that are listed at the end of this topic.

   If you have a multi-node appliance, add the second node. Then proceed to the next steps that are listed at the end of this topic.

   See Adding a node.